As a multi-function printer, Samsung Xpress C480W ticks all the boxes for your printing needs. The Xpress printer comes at an affordable price and is a suitable fit for your home or small office. lets see Samsung Printer Setup Xpress C480W in detail.

A few of the printer specifications are given below (for your reference):

When it comes to setting up the Samsung Xpress C480W printer for the first time, there is a two-setup protocol you must follow. Here are the steps.


The hardware setup for the Samsung Printer Setup Xpress C480W is complete.


Since the hardware setup is complete, it’s time to conclude the setup process with the steps for software installation.

  • Open the default browser on your computer.
  • Click the address bar and enter the URL for the printer support page.
  • Once the page opens, click the Software, Drivers and Firmware tab.
  • Click the Driver-Product Installation Software link.
  • Click the Download button for the driver.
  • Perform a double-click to run the installation for the downloaded file.
  • Wait for the connection screen to open.
  • Choose the method of connection.
  • Follow the commands on the screen and complete the setup process.

With the simple hardware and software setup steps, you can conveniently finish Samsung Printer Setup Xpress C480W easily.

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.