Printer Disappears After Sytem Reboot

Whenever you start rebooting your computer, your printer might disappear. It is recommended to check the status of your built-in Print Spooler Service. In some circumstances, the Print Spooler stops and you need to restart it again. By checking the status of your Print Spooler Service, you can fix the printer disappears after Reboot problem.

Solution 1: Restart The Print Spooler Service

Solution 2: Set The Print Spooler To Automatic

  • On the Print Spooler Properties window, select the drop-down menu under the Startup Type field.
  • Select Automatic from the available list.
  • Once done, click Apply and then select OK.

Solution 3: Enable File And Printer Sharing

It is essential to enable File and Printer Sharing for a computer to access the printer. perform the following steps to solve printer disappears after rebooting.

Turn on File and Printer Sharing in Network and Sharing Center:

Solution 4:

These are the most applied solutions to fix if the printer disappears after rebooting, and hopefully, you've learned how to resolve this issue.

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.