By performing the wireless setup for your Lexmark printer, you unveil the convenience of wirelessly printing documents and images. As Lexmark printers support fast printing, it is better to connect your printer to a wireless network. Here, you’ll learn how to perform the lexmark printer setup wireless in detail.

Complete The Hardware Setup For Your Lexmark Printer

Let’s start the Lexmark printer wireless setup.

Connecting Lexmark Printer Wirelessly Using Two Ways

If you've decided to connect your Lexmark printer by using the Automatic Connect method, do the following:

AUTOMATIC CONNECT METHOD:

If you want to connect your Lexmark printer by using the Manual connect method, do the following:

MANUAL CONNECT METHOD:

  • On your printer, press the Home button.
  • Select Setup and then press OK.
  • Select Network Setup.
  • Select Wireless and then select Network Connection Setup and then press OK.
  • Now, navigate to Wi-Fi Protected Setup and then choose Start Push Button Method.
  • Complete the on-screen instructions on your printer display to finish the wireless setup.
  • Or else, on your printer control panel, press the Home button.
  • Select Setup and then press OK.
  • Select Network Setup.
  • Select Wireless and then select Network Connection Setup.
  • Press OK.
  • Now, navigate to Wi-Fi Protected Setup.
  • Choose the Start PIN method and then copy the WPS PIN.
  • On your computer, open a web browser.
  • In the address field, type the IP address of your wireless router.
  • Log into the router config page.
  • Go to the WPS section, then type the eight-digit PIN.
  • Click Save.

Now, your Lexmark printer setup wireless connection is completed.

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call