HP Printer Won't Recognize My New Ink Cartridge Tank

The ink installation errors are common in HP printers. The problems in recognizing new ink cartridges can be fixed quickly with the steps given on this page. Before starting the troubleshooting process, verify whether you have correctly installed the ink cartridges into the print head holder. Ensure that you have removed the protective tape from the new ink cartridge before installing it in the printer. If necessary, remove and reinstall the ink cartridge into the printer. If the problem persists, proceed with the troubleshooting steps mentioned below to fix HP printer won't recognize new ink cartridge issue.

Solution 1: Power cycle your HP printer

  • Without turning off the printer, you have to remove the power cord from the printer and the wall outlet.
  • Disconnect any USB cable connected to the printer.
  • Wait for at least 2 minutes and reconnect the power cord to the printer.
  • Connect the other end of the power cord to the electrical outlet and power up the printer.
  • Wait until the LEDs begin to flash and the power LED turns solid white or green.
  • This will fix the ink cartridge recognition problem.
  • If the problem persists, move on to the next solution.

Solution 2: Perform a hard reset

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call