To proceed with HP LaserJet Pro MFP M148dw setup, take a look at the following steps and execute them in order:
To load the paper tray, refer to the following steps:
Install the toner cartridges.
You can also print envelopes and labels using your HP LaserJet Pro MFP M148dw printer.
A printer driver is a software that converts the print data (data to be printed) into a language or format that the printer can easily understand. The HP Laserjet Pro Mfp m148dw driver also sends (or transports) the data to be printed to the printer.
To view the online manual for your HP LaserJet Pro MFP M148dw setup printer, take a look at the following steps and execute them in order:
You can perform the Wi-Fi setup by using the mobile HP Smart app.
Make use of the following steps to perform the HP Laserjet Pro Mfp m148dw Wifi Setup:
On your printer's control panel, press the Wireless button and hold it. Release the button when the Ready LED and the Attention LED start blinking.
The Scan to Email feature is applicable for only the touchscreen models. Your printer's control panel can be used to scan a file (or document) directly to an email address. The scanned file can be sent to the email address as an attachment.
To use the Scan to Email feature, your printer should be connected to a network. Also, the Scan to Email feature must be configured, which can be done by making use of the Scan to Email Setup Wizard.
Perform the steps given below to scan a file and send it as an email attachment.
First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.
The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.
Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)
WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.
To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.