Issue: HP Laserjet Pro Mfp M130A Error Code 30

When you find the error message,  Er / 30, on the control panel of your HP LaserJet Pro MFP M130A printer, you will also see that the Ready  and the Attention  lights are in the ON condition on your printer. The Er / 30 is one of the most common issues that a user of this printer faces. This error sign obviously indicates that your printer is in an error state. To fix the HP laserJet pro MFP M130A error 30 , make use of the following methods:

Method 1-Resetting your printer:

In many situations, it has been found that Er / 30 is fixed by resetting your printer. To do the same, follow these instructions:

Method 2-Try plugging your printer directly into the electrical socket:

HP recommends that you plug your printer directly into the electrical socket to ensure that your power source works properly. To achieve this task, carry out the following instructions:

  • First, you need to disconnect the power cable from the back of the printer.
  • Unplug the power cable from any surge suppressors or power strips.
  • Now, plug the power cable directly into the electrical socket.
  • You can now reconnect the power cable to the back of the printer.
  • Press the HP LaserJet Pro printer’s power button to turn it on.
  • Check if the error message pops up again. If yes, then repeat the above procedure.
  • If you find that the problem persists, try using some other electrical socket.
  • In case the issue persists even after you use a different electrical socket, you might have to service the printer.
  • You have now fixed the HP laserJet pro MFP M130A error 30.
Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call