Remote UI (User Interface) is a software that enables you to have access and manage a machine that is connected to a wireless or a wired network using the web browser. The device is supplied and preinstalled with a web service software application that lets you use the Remote UI. The remote UI service enables you to check the printer's information and execute the functions in the utility window from a computer or smartphone. To set up the Remote UI interface in your Canon Printer, follow the how to setup remote ui on Canon printer directions as given below.

Follow the how to setup remote ui on Canon printer steps to setup Remote UI in your Canon printer.

  • Open the web browser on your computer or smartphone and enter the Printer IP address.
  • Enter the username and administrative password. 
  • Bydefault, the username is Admin and the password is password.

The Remote UI page will now be displayed on the left side of the screen with the following details:

Printer status


AirPrint settings

Google Cloud Print setup

Firmware update

Manual (Online)

Network Configuration

Even while using the above given how to setup remote ui on Canon printer instructions, in need of more guidance click the call button available on the top.

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.