Remote Desktop Setup Windows 10

The remote desktop is one of the features of the Windows 10 operating system and you can also use the Remote Desktop app downloaded from the Windows store. With the help of the remote desktop feature, you can access any computer on your network remotely. The configuration of the remote desktop is quite a task, and you have to make additional settings and connect through different ports to connect your Windows 10 computer to a remote desktop successfully. Follow the below given how to setup remote desktop Windows 10 to make remote desktop connection.

Make sure that you have enabled the remote desktop feature on your Windows 10 computer.

  • On your Windows 10 computer, click the Windows (Start) icon located at the bottom left corner of the screen.
  • Locate and open the Control Panel option and proceed with how to setup remote desktop Windows 10 steps.
  • Click the System and Security option on the left side of the Control panel pane.
  • Click the System option and then click the Advanced System settings option.
  • Click the Remote tab.
  • While following how to setup remote desktop Windows 10 guide, In the Remote Desktop section, click the radio button beside the ‘Allow the remote connection to this computer’ option.
  • Click Apply and click the OK button.
  • The moment you have completed these steps, the Windows 10 computer will allow remote desktop connections for remote desktop setup Windows 10.
  • The Windows 10 computer will automatically add the necessary rules for the built-in firewall.

Now you have to set up the Remote desktop with a permanent IP address.

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.