HP Deskjet 3632 is an All-in-One wireless printer with printing, copying, and scanning capabilities. Setting up the HP Deskjet 3632 printer is much easier. Proceed with the how to setup HP deskjet 3632 guidelines that are given below to set up the printer.

STEP 1: UNPACKING THE PRINTER

STEP 2: CONNECTING THE POWER CORD.

STEP 3: INSTALLING THE INK CARTRIDGES

  • Once the printer is turned on, it performs the startup process, and the carriage moves to the center portion.
  • Now on following how to setup HP deskjet 3632 steps, open the front door of the printer. Make sure the printer is silent or idle and lower the ink cartridge access door.
  • Remove the plastic cover from the ink cartridges and pull out the orange tab to remove the tape.
  • Make sure to hold the cartridges by the plastic part and do not touch the ink nozzles or contacts.
  • Now, insert the cartridges one by one into the empty slots.
  • Push it inside by lifting the cartridge to an upward angle to hold it into place.
  • Finally, close the ink cartridge access door and main door.

STEP 4: LOADING PAPER

STEP 5: INSTALLING THE SOFTWARE

Note: If you face any issues while setting up the HP Deskjet 3632 printer using HP deskjet 3632 guide, contact our technical support team.

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call