HP Deskjet 2652 Unboxing Setup

HP Deskjet 2652 is an All-in-One printer that supports the USB as well as wireless connection interfaces. To perform the initial setup of the HP Deskjet 2652 printer, refer to the step-by-step instructions how to setup Hp Deskjet 2652.


ACCESSORIES INCLUDED IN THE BOX:

STEP 1

STEP 2

STEP 3

  • Open the HP Deskjet 2652 printer’s front cover.
  • Take a tri-color ink cartridge from the package.
  • Remove the tape that is present at the tri-color ink cartridge.
  • Insert and then push the tri-color ink cartridge in its slot correctly.
  • Do the same again to place the black ink cartridge in the HP Deskjet 2652 printer.
  • After closing the cartridge access cover, close the printer’s output tray.
  • Follow these steps we can execute that how to setup HP Deskjet 2652.

STEP 4

Compatible paper:

STEP 5

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.