Setting Up Your Ethernet On Pc

The Ethernet connection, also called as the cable Internet, helps you in bringing out the best internet speed to your network. With the help of the Ethernet connection, the speed can be 10 times more than that of the dial-up connection. There was a time when technicians were required to set up a home or office network connection. But now things are a little different as you can easily make the connection by yourself. All you need is a router, a modem, and an Ethernet cable to make the connection. We will now be walking you through different methods here, so you have a easy way to know how to setup ethernet on PC.

Method 1: Direct Connection

  • Initially, connect the router and modem using an Ethernet cable.
  • The cable from the modem should be connected to the WAN port of the router.
  • Now, take another Ethernet cable.
  • Connect an end of the Ethernet cable to your PC and the other end of the Ethernet cable to the LAN port of the router.
  • Make sure the router is turned on and has a stable internet connection. Else, just see if the internet light on the router is glowing (indicates that it has the connection).
  • Now, you could notice the Network icon on your computers System Tray turned on.
  • You can open a browser and access the Internet now.

Method 2: Using Windows Settings

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.