How To Setup Dns Server?

DNS (Domain Name System) server helps to translate the domain names to the IP address that the Internet understands. Your ISP would provide the DNS, which is generally a public server that works slow. You can set up a private DNS server to maintain the local network computers or clients. Continue reading to learn how to setup DNS server on Windows Server 2012.

Step-1: Set a Static IP address for the computer

  • On the desktop, use the search bar to open the Network and Sharing Center window.
  • When the window appears, click Change adapter settings, then right-click the Ethernet network card you are connected to.
  • Choose Properties, select ipv4 from the list, and click the Properties button.
  • Select ‘Use the following IP address’ and then enter the IP address, Subnet mask, and Default gateway.
  • Below that, select ‘Use the following DNS server addresses’ and enter the preferred DNS server.
  • Make sure the router and DNS server use the same IP address and click OK.
  • Close the window and then open the Server Manager.

Step-2: Set up the DNS service

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call