This web page contains simple how to setup Canon printer on Ipad instructions to setup the Canon printer on your iPad.

Setting Up The Canon Printer On Ipad Using Airprint:

  • Check if your Canon printer supports the AirPrint feature.
  • Finish the initial hardware setup of the Canon printer.
  • Ensure that the power cable is securely connected between the Canon printer and an electrical outlet.
  • Power up the Canon printer by pressing the Power button.
  • Connect the Canon printer to a wireless network.
  • Go to your iPad, tap the Settings icon, and select the Wi-Fi option and proceed with how to setup Canon printer on Ipad guide.
  • Choose the same wireless network that your Canon printer is connected to.
  • If you see a prompt message, enter the wireless network key (password) and tap the Join option.
  • Note: Both the Canon printer and the iPad must be connected to the same wireless network.
  • Go back to the home screen of the iPad and tap the Photos icon to open its application.
  • Select and open the photo that you need to print on the Canon printer.
  • Tap the Share icon followed by the Print option.
  • Now, the Printer Options screen.
  • After you tap the Select Printer option, select the model name of the Canon printer.
  • Touch the Print option at the bottom of the screen to print the selected photo on the Canon printer.

Setting Up The Canon Printer On Ipad Using The Canon Print Application:

If the Canon printer does not support the AirPrint feature, refer to the following how to setup Canon printer on Ipad instructions to set up the Canon printer on the iPad using the Canon Print application.

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.