Canon Pixma Mg3222 Setup

Canon PIXMA MG3222 is a wireless color photo printer that can print, copy, and scan. It comes with an LCD panel, 100 sheet Auto Sheet Feeder, Auto duplex printing, and mobile printing capabilities. If it is your first-time setup, follow the below-mentioned how to setup Canon pixma Mg3222 steps.

Basic Setup:

  • You need to unpack the Canon PIXMA MG3222 printer first.
  • Next, take out the necessary printer supplies such as power cord, setup CD-ROM, ink cartridges, user guide, and warranty card.
  • Remove all the orange protective tapes and covers from the printer.
  • Open the printer's front cover and extend the paper support for Canon Pixma Mg3222 Setup.
  • Load some plain papers into the front paper tray and move on with how to setup Canon pixma Mg3222 guide.
  • Make sure that you load the print side of the paper facing down.
  • Next, align the paper guides with the stack of paper without damaging the paper.
  • Open the paper output tray and make sure that you have extended the paper support.
  • To install the ink cartridges, open the front cover of the printer and lower the paper output tray.
  • Open the paper output cover and wait until the ink carrier moves to the home position.
  • Unpack the black ink cartridge and remove the protective seal.
  • Make sure not to touch the copper-colored part on the ink cartridge.
  • If you touch the ink nozzle area (copper-colored part), you might end up with the poor print quality in the future.
  • Install the black ink cartridge into the right-side ink carrier after releasing the lock lever.
  • Follow the same procedure to install the color ink cartridge into the left side ink carrier.
  • Make sure that you have locked the ink cartridge levers before closing the printer's front cover.
  • Connect the Canon printer to a wall outlet using the supplied power cord for Canon Pixma Mg3222 Setup.
  • Turn on the printer setup and configure the basic printer settings.
  • Install the printer software on your computer using the setup CD-ROM.
  • Verify the print function after installing the printer driver.
  • If you face any trouble while setting up the Canon PIXMA MG3222 printer using how to setup Canon pixma Mg3222 guide, contact our technical support team.
Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call