How To Setup Blue Iris Web Server?

Blue Iris Web Server helps to create a LAN or Internet home web page on your computer. Using this server, you can view your camera and recordings from a different system (anywhere and anytime). When you install Blue Iris, the webserver is enabled automatically. You can configure it for local network use. If you want to view your home page on a web browser, click the Earth toolbar icon. Because of ActiveX Control, you can open the home page only using Internet Explorer. If you try to open in any other web browser, it will appear as JAVA script. To edit the Blue Iris Web Server configuration, click the Options toolbar icon and navigate to the Web Server tab. Carry out the below-mentioned steps on how to setup blue iris webserver.

Port number

  • Select the checkbox next to the ‘Enable the https web server on port’ option and then select 81 its drop-down menu.
  • Do not change this port 81 unless you have any specific reason to do so.
  • The default https address is 80. But, it is blocked by ISP’s incoming connection. It is very difficult to forward through your wireless router if you use the port 80.

Local, internal (LAN) access

Remote, external (Internal) access

Advanced

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call