How to Set Up Access Point with Wireless Router

Here's how to Setup Access Point with wireless router can be done with ease using the quick steps given below. Before configuring your access point (AP), choose how you wish to connect it to the router. You can configure it as a Wireless Access Point or as a Wireless Repeater.

Wireless Access Point Cable Setup:

Steps to configure Linksys Wireless Access Point:

Steps to configure TP-Link access point:

  • Before starting, verify whether you have properly connected the TP-Link access point to the computer.
  • Open the default browser and enter the access point’s IP address in the URL field.
  • Press the Enter key to open the access point’s login portal.
  • Enter the login credentials to access the web-based setup page.
  • Click the Wireless tab from the left-side panel and configure the necessary wireless settings for your access point.
  • Once configured, click the Save and Apply button.
  • If you face issues while how to setup access point with wireless router, contact our technical support team for remote assistance.
Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.