The printer setup utility or print center is an in-built application on a Mac computer. It enables the users to choose the printer, which has been already installed from a network connection. It allows you to choose the printer you prefer from a list of installed printers. If you want to know how to find printer utility on Mac, continue to read the following sections.

If you have already added your printer to your Mac computer, navigate to the printer utility section by following the instructions mentioned below.

Find Printer Utility On Mac

If you haven’t added your printer to your Mac computer yet, you can go to the printer setup utility section, just as mentioned below. You can know how to find printer utility on Mac using the Go menu or the hard drive icon.

ACCESS THE PRINTER SETUP UTILITY USING THE GO MENU

  • Click on the Go menu and choose the Applications option.
  • Locate and double-click on the Utilities folder.
  • Locate and double-click on Printer Setup Utility/Print Center.
  • If you want to add your printer now, click on the Add printer option and follow the on-screen step-by-step instructions.
Printer Utility Folder

ACCESS THE PRINTER SETUP UTILITY USING THE HARD DRIVE ICON

In this manner, you know how to find printer utility on Mac. If you have any issues, you can reach out to us.

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call