HP Deskjet 3630 Wifi Setup

The HP DeskJet 3630 is an All-in-One wireless printer. It performs all three functions --- print, scan, and copy. The printer’s control panel is simple and helps you perform all the functions easily. The printer is known for its sleek design. The HP DeskJet printer allows you to print from wireless devices like your smartphones and tablets easily. One of the best features of the HP DeskJet printer is the wireless interface. You will now be seeing the how to connect HP Deskjet 3630 to wifi steps to connect your HP DeskJet 3630 printer to WiFi. Before you proceed with the WiFi setup, you will have to complete the initial setup.

  • Make sure you have your computer connected to the WiFi and the signal is stable.
  • Make sure the computer has been connected to the same network as the one you are going to connect the HP DeskJet printer.
  • And most importantly, the initial setup of the printer should have been completed.

There are two types in which you can connect the HP DeskJet 3630 printer to WiFi.

PBC Method (Push Button Configuration):

You can only use this step if your wireless router has a WPS button. It is one of the easiest modes for connecting the printer to WiFi.

HP Printer driver:

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.