Connect Canon Ts3122 To Wi-Fi

Do you want to print wirelessly? Proceed with the how to connect Canon Ts3122 to wi-fi steps that are given below to connect the Canon TS3122 printer to your Wi-Fi network.

Step 1: Initial Process

  • Ensure that you have made all the hardware connections on Canon TS3122 before connecting the printer to your Wi-Fi network.
  • Connect the power cord to the rear side of the printer and plug the other end to an AC outlet.
  • Set up your wireless router and configure it prior to the installation.
  • Note down the SSID and password of the wireless network for connection.

Step 2: Connecting the printer to the Wi-Fi network

Step 3: Installing the printer software

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.