Proceed with any of the how to connect Brother Hl L2350dw printer to wifi procedures given on our web page to connect the Brother HL L2350DW printer to Wi-Fi.

Procedure 1

Procedure 2

  • To perform this method, your wireless router must support WPS.
  • Go to the control panel of the Brother HL L2350DW printer, select the Network option using the up or down button.
  • Press the OK button and select the WLAN option,followed by the WPS option.
  • If the WLAN Enable message displays on the LCD panel of the printer, select the On option by pressing the down arrow button.
  • Now on using how to connect Brother Hl L2350dw printer to wifi steps, the wireless setup wizard will begin automatically.
  • As soon as you see the Press key on rtr message, go to the wireless router and hold the WPS button.
  • Go back to the Brother HL L2350DW printer’s control panel and press the up arrow button.
  • The printer searches for the wireless network and connects to it.
  • If the wireless network connection is established successfully, the Connected message will appear on the LCD panel of the Brother HL L2350DW printer.
  • Download the Full Driver & Software Package file from the manufacturer website and then install it on your computer following the on-screen guidelines.

Procedure 3

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.