When you need to print a document, but have not connected your printer and laptop yet, you cannot print the documents you want. In that case, it is recommended to add your printer to your laptop to print the documents/images seamlessly. Continue to read the following sections to know How To Add A Printer To Dell Laptop.


  • Take out the installation disk that came along with your printer and insert it into your computer’s CD drive.
  • Next, open the folder and run the setup file.
  • Now, agree to the end-user license agreement and install the printer driver by following the on-screen instructions.
  • If your computer doesn’t have a CD drive, or if you have misplaced the installation disk, you can easily download the printer driver from the manufacturer’s official website.
  • On your computer, launch your browser and go to the manufacturer’s official support page.
  • Enter your printer model and download an appropriate printer driver recommended for your operating system and continue to know How To Add A Printer To Dell Laptop.
  • Once the download gets completed, go to the destination folder and run the setup file.
  • Now, install the driver on your computer by following the on-screen instructions.
Add Printer To Dell Laptop


Adding Printer
Adding Printer To Print


  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.