How To Solve Epson Printer Communication Error Mac?

You might be relying on your Mac for various purposes. But sometimes, it might pose some issues. When you have a peripheral device such as an Epson printer connected to your Mac, you are prone to face some additional problems. In some situations, your Epson printer would become unable to communicate with your Mac computer. This case will surely be frustrating, especially when you are in the middle of some urgent business.

On this page, let us look into the Epson printer communication error mac. When this scenario happens, you cannot print anything. Even if you give the Print command, your Epson printer will refuse to print anything. This is because there is no proper communication between the printer and computer. So, you have to figure out the root cause of the issue so that you can troubleshoot it easily.

Reasons behind the issue:

Some of the common causes of the issue are listed below:

  • A faulty power cable might be the reason.
  • There might be some problem with the power socket.
  • The cable connection between the printer and the computer could be loose.
  • Outdated printer driver couldbe the cause.
  • If you have connected your printer wirelessly to your Mac computer, there might be some network connectivity issues.
  • Some problem that lies with the printer hardware could be the cause.

Method 1 - Checking the cables and connections:

Method 2 - Checking the wireless connection:

Method 3 - Fix the issue with the printer drivers:

Method 4 - Confirming that AppleTalk is active:

NOTE: This method will not apply if you have recently updated your system software to Lion because it does not support AppleTalk anymore.

Method 5 - Removing the printer and adding it:

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call