Setting Up Dell V515w Printer

Dell V515w is an All-in-One printer and the setup involves unboxing the printer, loading paper, installing the ink cartridges, and installing the printer software. For detailed instructions about Dell V515W Printer Setup, continue reading the steps given on this page.

Unboxing And Basic Setup:

Loading Paper:

  • Open the paper support and slide apart the paper guides.
  • Fan a paper stack and load it into the rear feed slot of Dell V515W Printer Setup.
  • Adjust the paper stack with the paper guides.
  • Pull out the paper output tray.
  • Select the paper settings on the LCD panel.

Installing The Print Head And Cartridges:

You have now completed the hardware setup for your Dell V515w printer. Continue reading the steps to complete the Dell V515w printer setup.

Installing The Printer Software:

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.