The Dell 1110 printer Setup is very compact. So, it tends to take up only a little room on your workstation. With a 600dpi resolution, the texts are so clean, which makes it one of the top choices for a home or a small office printer. Even though the Dell printer is of miniature size, it can print at a speed of 16 pages per minute.


 Dell Printer Setup

When it comes to the basic setup of Dell 1110 printer, there are two setup procedures you must follow. Keep scrolling to read more.

 Dell 1110 Printer Unboxing


Printer Setup

Dell 1110 Ink Cartridge

Ink Cartridge Setup

Toner Cartridge Placement

Dell Printer Ink Replacement

Dell Printer Paper Stack

Paper Width Guide

Dell 1110 Setup

Power On The Printer


  • Since the Dell printer comes with an installation CD, place it into the CD/DVD drive of the computer.
  • When the installer window opens, select your language and agree to the terms and conditions.
  • Follow the prompts and wait for the connection screen to open.
  • Since the printer supports only the wired connection, select the USB connection option.
  • Complete the software installation then and there.

That’s all you need to know about the Dell 1110 printer setup. If you wish to have your queries answered, click the CALL button on this page. Our dedicated technical team will assist you throughout the Dell printer setup process.

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.