Solutions - Computer Not Find Printer On Network

Wireless connection enables convenient communication between your printer and computer. However, if your Computer Can't Find Printer On Network, your entire setup is in vain.

If your computer can’t find your printer on the network, here is the list of things you need to check before proceeding with the actual troubleshooting method:

Make sure:

  • The printer is turned On.
  • Your computer (Windows or Mac) and printer are connected to the same local network.
  • The printer driver is up-to-date.
  • Printer Firmware is updated.
  • The File & Printer sharing option is enabled for the printer.

After ensuring that the above-mentioned factors are set right, proceed with the steps below:

Method 1: Enable “Network Discovery”

The Network Discovery option helps your computer detect the devices that are connected to the same network. Check whether this option is disabled on your computer. If yes, enable it. To do so, follow the instructions below:

Now, try to perform the print operation. If your computer still can’t find the printer on a network, then perform the next method given below.

Method 2: Enable “File and Printer Sharing”

The printer may not get recognized by the computer over a network if the File and Printer Sharing option is disabled on your computer. To enable this option, follow the below instructions.

If the Computer Can't Find Printer On Network issue persists, contact our technical team for remote assistance in fixing the issue.

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.