HOW TO SOLVE CANON PRINTER PAPER NOT FEEDING IN STRAIGHT?

If the paper is not feeding straight on your Canon printer, then scroll down this page to know the cause and solutions to clear this issue.Note: The below solutions are suitable for the Canon PIXMA MG series printers.Usually, the paper will be fed properly if it is loaded correctly. But, at the same time, if the feed rollers have dust or dirt particles, the paper will not feed properly. So, once you notice the Canon printer paper not feeding straight issue with paper feeding on your Canon printer, clean the rollers twice. The first time you need to clean the rollers with paper and the second time without paper. 

CLEANING THE ROLLERS WITH PAPER


Canon Printer Paper Not Feeding In Straight

CLEANING THE ROLLERS WITHOUT PAPER

  • Turn on your Canon printer.
  • Remove all the paper left in the rear tray.
  • Now, press and hold the Stop button.
  • Once the orange light on your printer’s control panel starts to flash, release the button.
  • Now, the feed roller cleaning process will be initiated. 
  • Once the cleaning process is completed, check whether the paper is feeding straight on your Canon printer. If not, clean the feed rollers using a cotton swab. To do so, follow the below instructions.
  • Turn off your Canon printer setup.
  • Unplug the power and network cables from the printer.
  • Get a cotton swab dipped in water.
  • Wipe the feed rollers with the swab.
  • After clearing the rollers, wait for them to dry.
  • Reconnect the power cord and turn on your printer.
  • Load paper in the rear tray and check if the paper is feeding straight on the Canon printer. 

If the paper is not feeding straight on the Canon printer even after cleaning the rollers, then get remote assistance in resolving this Canon printer paper not feeding straight issue by clicking the Call us button provided on this page.

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call