The Canon Printer Not Work

If your Canon printer not detected Windows 10 computer, then begin the troubleshooting process with some initial checks given below.

Solution 1 - Run the Windows troubleshooter

  • To start with, check whether the printer is turned 
  • Check if theUSB cable is firmly connected and make sure it is not damaged.
  • Make sure the printer isn't turned ONbefore the installation process. If so, then turn your printer OFF.
  • Unplug the USB cable.
  • Connect the USB cable again.
  • When you see the below screen, turn the printer ON.

Updating the printer driver:

Sometimes, updating your printer driver manually may help you to resolve this issue.

Method 1

 To open the Run command, hold the Windows and R keys together and type devmgmt.msc.

Method 2

If your printer driver doesn't have any update for your OS, then try installing in the compatibility mode. This mode helps the printer to run the program using the previous Windows version.

Here are the steps to install the Canon printer driver in compatibility mode.

Still, if the Canon printer not detected Windows 10, contact our technical support team.

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.