Canon Printer Error E02

On this page, let's see how to resolve Canon printer error code E02 on your Canon printer.

Now, let's get started.

When Error E02 happens, the Canon printer's alarm LED turns orange and displays an error code on the printer's screen. The same error will show support codes like 1000, 3442, 3443, 3444, etc., on your computer screen as well.

Error E02 occurs due to many reasons. Some of them are,

Try the following solutions to resolve Error E02 on your Canon printer.

Clear Any Paper Jam

Reload Papers

Clear The Paper Feed Rollers

Error E02 While Duplex-Printing

  • While you are performing manual duplex-printing, the error E02 occurs when the printer has printed on one side.
  • So, to fix the issue, take the printed paper from the output tray and reload it on the printer to print on the other side.
  • Now, the Canon printer error code E02 will be fixed.
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.