Rectify Paper Not Feeding Issue On Canon Mx432 Printer

On this page, you’ll learn how to resolve the Canon MX432 paper not feeding issue.

Encountering an error while using the printer is one of the most common things. Most errors or issues are easy to identify and resolve. Paper not feeding   is a common issue encountered by all printer users at some point. The below section explains how to resolve the paper not feeding issue.

There are many causes for the paper not feeding error to occur. As soon as you encounter the paper not feeding issue, perform the basic solutions discussed below. If the basic solutions couldn’t resolve the paper not feeding issue, then you need to perform the advanced solution like cleaning the paper feed roller.

Basic Solutions

  • Check whether any paper is jammed or stuck inside the printer. If yes, clear the jammed paper from the printer.
  • After clearing the jammed paper, reload the paper and check whether the same error persists.
  • If yes, check whether you have loaded the recommended paper type. If not, remove it completely from the tray and load the tray with the recommended paper.
  • Make sure to align and load paper properly in the tray.
  • While loading paper, make sure not to overload the tray because it may also lead to the paper jam error.
  • Restart your Canon printer and check if the Canon MX432 paper not feeding problem is resolved.

If the above-mentioned basic solutions don’t resolve the paper feed problem, then clean the paper feed roller to fix this error.

Advanced solution - Cleaning the paper feed roller

If the Canon MX432 paper not feeding issue persists, get assistance from our experts to fix it.

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call