Although the Canon MG3222 printer is quite an efficient machine and yields printouts of very high quality, users face some issues while setting it up or printing from it. There could be various reasons behind these issues. Whatever the reason, there are some troubleshooting techniques to resolve them. One of the most common errors that the users encounter is Canon MG3222 printer not responding.This error message could pop up when you are trying to print in a wireless LAN environment. Some of the causes of this error and the tips to fix them are provided here:


  • In case the printer is on, press the ON button to power it off.
  • Now, wait for 10 seconds. Next, press the ON button to turn on the printer and continue to fix the issue due to which the Canon MG3222 printer is not responding.
  • If there is a Power button on the router, press it so that the device turns off. Now, you need to wait for 10 seconds and turn on the router again. In case the router does not have a Power button, you have to disconnect the power cable (or the AC adapter).
  • The above steps should help the router and printer communicate. If you need remote assistance to fix Canon MG3222 printer not responding issue, call us.
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.