Cannot Connect To Printer Error Code 0x00000771

The Error 0x00000771 will pop up at times because of misconfigured system files in the Windows operating system. If that is the case, you will find the computer to be slower and the response time will lag as well. Also, if you run several programs simultaneously, then the computer is expected to encounter a sudden crash. The reasons behind the Error Code 0x00000771 are,

We will be discussing some troubleshooting methods to get rid of the Error code 0x00000771 and then try connecting the printer to the computer.

 

METHOD 1: START PRINT SPOOLER SERVICE

You can encounter this problem because the spooler service has come to a halt. Follow the steps to start the Spooler service again.

 

METHOD 2: PRINTER DRIVER

  • An invalid printer driver can lead to a lot of issues and as a result, you will find the error code 0x00000771.
  • Make sure you download the valid printer driver that is compatible with the Windows operating system.
  • You can download the printer driver from the official support page of your printer. 

METHOD 3: REINSTALL DRIVERS

METHOD 4: FIRMWARE UPDATE

METHOD 5: TURN OFF AND TURN ON

　
Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call