Quicks Steps - Fix Brother Printer Error 20 01

You may receive the Brother printer error 20 01 when there is an issue in sending or receiving a fax message by the printer. The error might be caused due to an issue with the telephone line, alarm system, or any other device related to the fax operation.

Here are a few quick steps to fix this error. The detailed procedure to perform the fax connection is discussed below.

Method 1: Check the quality of the dial tone

Method 2: Re-perform the fax connectivity

  • Check whether the phone cord is connected to your Brother securely. If not, unplug and reconnect the cord.
  • Make sure that you have connected the telephone line cord directly to the telephone wall jack.
  • Similarly, make sure that the cord is connected to the LINE port of your Brother printer.
  • Now, try to send or receive the fax message.
  • If the Brother printer error 20 01 persists, try outthe next method given below.

Method 3: Reconfigure the compatibility settings of your printer.

Faq
  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.

call