Are you looking for an effortless way to add Ricoh printer to Mac? Get it done within a few minutes. The process involves downloading the Ricoh printer driver and adding the printer using the add printer wizard on your Mac. Although it looks like an extensive process, the longest way round is the shortest way home. For detailed instructions, go through the steps given below.


  • Ensure that your Ricoh printer is turned on.
  • Prepare the USB cable to connect your printer to your Mac.
  • If you wish to connect the devices over a wireless network, configure the wireless settings on the Ricoh printer control panel.



Once Add Ricoh Printer To Mac is successfully done, you can see it in the Printers list of the Printers & Scanners window.

  • Why is my wireless printer not printing?

    First, try restarting your computer, printer and wireless router. To check if your printer is connected to your network: Print a Wireless Network Test report from the printer control panel. On many printers pressing the Wireless button allows direct access to printing this report.

  • Why is my printer showing error?

    The other most probable reason for the printing error is the connection between your computer and the printer. If you are sure that the transmission cable is working okay (tested the printer on another computer), then the problem might be the drivers. This can be the printer drivers or the USB port drivers.

  • Why do my 3d prints keep failing?

    Another common fail is over extrusion. Over extrusion happens when your 3D printer pushes out too much plastic too fast, causing a jam in the end of the nozzle. ... Make sure YOURu layer height is less than your nozzle diameter. Increase your cooling fan's power (this will cool the plastic and cause it to slow down)

  • What is the WPS button?

    WPS stands for Wi-Fi Protected Setup. It is a wireless network security standard that tries to make connections between a router and wireless devices faster and easier. WPS works only for wireless networks that use a password that is encrypted with the WPA Personal or WPA2 Personal security protocols.

  • How do I reset my printer?

    To restore your HP printer to factory-default settings, follow these steps. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on. Release the Resume button.